9KTGNGUU"2QQN15RC"6JGTOQOGVGT
OWNER’S MANUAL —
Please read before using this equipment.
63-1037
Liquid Crystal Display — The
current temperature and selected
channel appear.
Wall Mount Holder — Use to mount
the thermometer on a wall.
POOL
SP
A
Removeable Stand — Use to set
thermometer on a table or other flat surface.
Temperature Sensor Probe — Place it in
water to test the temperature.
Channel 1/2/3 — Slide to Channel 1, 2, or 3. Set
to a different channel than the other remote
sensors you are using.
WIRELESS THERMOMETER
°C / °F — Select Centigrade (°C) or
Fahrenheit (°F) for your desired degree
format.
y — Appears if the batteries are weak.
Thank you for purchasing the RadioShack
Wireless Pool/Spa Thermometer. Your
thermometer measures water temperature,
and is useful in swimming pools, hot tubs,
and freezers. It is for use with an in/out
thermometer (not supplied, available at your
local RadioShack store or online at
mount holder and stand let you mount it
wherever you like.
3. Slide CHANNEL 1/2/3 to the desired
setting, then press RESET. The selected
channel appears on the display.
4. Slide °C/°F to the desired setting.
±"016'"±"
Operation
5. Place two batteries in the compartment
as indicated by the polarity symbols
(+ and –) marked inside.
• Do not set two or more thermometers to the
same channel when using them with one
main unit. Otherwise you will unable to judge
which thermometer the digits represent.
6. Replace the cover and secure it with the
• Your thermometer comes with a protective
film covering the display which should be
removed before use.
screws. Rý
+056#..+0)"
Selecting a Location
12'4#6+10
$#66'4+'5
The construction of your home or office might
affect the transmission range between the
main unit and the thermometer. If you have a
choice of several locations, try each to see
which provides the best performance.
Place the temperature sensor probe where
you want to test. The current temperature
and selected channel appear. Signals
transmit to the main unit about every 30
seconds. ±
Your thermometer requires two AA batteries
(not supplied) for power. For the best
performance and longest life, we
recommend RadioShack alkaline
batteries.Rý.
"9#40+0)"
Dispose of old batteries promptly and properly.
Do not burn or bury them.
R
R
1. Remove the wall-mount holder from the
back of the thermometer.
4'5'66+0)"6*'"5;56'/
If your thermometer stops working properly,
use a pointed object to press RESET. This
resets the temperature and reinitializes the
sensor transmitter.
2. Use a Phillips screwdriver to loosen the
screws on the battery compartment
cover and remove the cover.
."%#76+10".
• Use only fresh batteries of the required size
and recommended type.
°C/°F
RESET
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
CHANNEL 1/2/3
/1706+0)
Place your thermometer on a flat surface
using the supplied stand, or mount it on the
wall using screws (not supplied) and the
supplied holder.
• If you do not plan to use the thermometer for
a month or more, remove the batteries.
Batteries can leak chemicals that can
destroy electronic parts.
5'.'%6+0)"#".1%#6+10
Choose an indoor or outdoor location for
your thermometer that is within 60 – 90 feet
(20 – 30 meters) of the main unit. ±
Battery
Compartment
Cover
"+/2146#06"
#
#
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by
RadioShack Corporation.
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon
for pertinent information.
— Warning
— Important
± — Note
. — Caution
° — Hint
#
Rý
|